1 x BMA
2 x Pole mounting clamps
1 x Power cable
Mounting process on a light pole
The camera is attached to the pole by using clamps. These adapt to the diameter of the pole.
A hole is drilled underneath the camera, where the cable gland with seal is then screwed in place. The cable is fed through the pole to the ground at this point. At the other end of the cable is the appropriate plug (2 or 3-pin) for the BMA
There is a cover in the lower section of the light pole. This can be opened with a special key to get the battery inside the pole. The power supply with plug or terminal strip should also be located here.
There is a two-pin plug on the battery that is used to charge the battery and a two-pin cable that is used to power the camera. If a terminal strip is available instead of a connector strip, the connector can be disconnected and the cables can be clamped directly into the terminal strip.
Diameter min. 10 cm
An intelligent optical system for monitoring road users and the flow of traffic. of the traffic flow
| Input voltage | 230 V AC with integrated charge controller |
|---|---|
Output voltage
12 V DC
Energy reserve
18 h
Maximum power
21 W
Capacity
380 Wh
L x W x H
790 mm x 80 mm x 62 mm
Connections
for the camera: 3-pin connection for the power supply type F plug
BMA specifications
| Data transfer | |
|---|---|
| General | Variant AC | Variant DC |
|---|---|---|
| Certification | |
|---|---|
The BMA processes personal data only vaguely, without storing it and only for the purpose of anonymization. This is done on the basis of Art. 6 para. 1 f) GDPR, namely in the legitimate interest of the operator. Only the anonymous data is then used to carry out traffic management. The BMA complies with the Low Voltage Directive 2014/35/EU and the Electromagnetic Compatibility Directive 2014/30/EU. This resulting CE certification is attached to the bottom of the device.
The supplier assumes no liability for compliance with local requirements or additional certifications that may be required in certain regions or markets. It is the responsibility of the purchaser or user to ensure that the product complies with local regulations and specific requirements that may go beyond the specified certifications. The supplier disclaims all liability for any damage or loss that may result from non-compliance with such additional requirements.
Data streaming protocol
MQTT
Data encoding
JSON
Data transmission
LTE
Operating conditions
-20° C - +50° C
Power supply
220 - 240 V AC
12 / 24 V DC
Frequency range
47 - 63 Hz
N/A
Power consumption
230 V AC 50 Hz
14 W
Material
Housing: Polycarbonate Rain cover: Polycarbonate 3D printing
Protection class
IP65
Dimensions
210 x 155 x 140 mm (L x W x H)
Weight
2000 g
Mounting method
Pole mounting, clamping range 60 - 150 mm
GDPR-compliant
yes
